Note: Watch the Video First, Then Read The Article
What Is There In The Video?
First, the man connect the bulb with A.C current, Suddenly the bulb gets glow up. Then he join some parts with the bulb and then he connect the bulb with current, the bulb gets glow up, He disconnect the supply But the bulb keep glowing,
In that video, There is no procedure and he didn't explain anything,
But Here I can explain you about the video
Procedure:
src="https://blogger.googleusercontent.com/img/b/R29vZ2xl/AVvXsEiySJkFaLRt0vHPz2S8U-0tpIBpmw5S8qERlZu_xcvU9OTsdKE-k_lqdS-QtmcNGVMzhFPSQPMuu95stju3fLwJmvyzkozL3291bTJhGPKdM2I39BygffVMsfh1a0SY4XtR5ApSYq80Ihk/s320/download.png" width="320">
Though he disconnect the power supply, there is some emf(Voltage ) in the coil
Note: When the conductor cuts the magnetic flux, the emf (voltage) is induced in the conductor
The current flow after the supply is disconnected, The bulb will glow only for few seconds (may be 2 to 5 seconds).
- So there is some voltage even the supply is disconnected
- The MOSFET block the current flow in reverse
- So, The Bulb glow for some time after the supply is disconnected
Time Range
The current flow after the supply is disconnected, The bulb will glow only for few seconds (may be 2 to 5 seconds).
In this video, He had done it again and again, after he cut the part of the video which he was reconnected the supply and again disconnected. So the video is totally not real but also totally not fake
If you have you any doubts, Comment below
If you have you any doubts, Comment below
Thank You For Reading,
0 Response to "Free Energy Light Bulb? Is It True?"
Post a Comment